The detector should be installed in a place where gas is easy to leak, and the specific location should be determined according to the specific gravity of the detected gas relative to air. When the specific gravity of the gas to be detected is greater than that of air, the detector should be install... read more
The controller is connected to the detector with a three-core shielded wire (note: the single-core wire diameter is not less than 0.75mm national standard wire, depending on the actual distance), and the shielding layer is connected to the controller casing and grounded reliably. When RVV cables are... read more
⑴ Newly added sensor drift automatic compensation function, which truly prevents false alarms and false positives ⑵Alarm failure prompt function, so that users can replace and repair, and prevent non-reporting ⑶ MCU full control, the working temperature is -40 degrees to 80 degrees ⑷Integrated: It i... read more
(1) Find out the possible leakage points of the device to be monitored, analyze their leakage pressure, direction and other factors, and draw a distribution map of the probe position, and divide them into three grades of I, II, and III according to the severity of the leakage. (2) According to speci... read more
Gas alarms are generally judged by detecting the concentration of leaked carbon monoxide gas; gas alarms are generally judged by detecting the concentration of leaked combustible gases such as alkanes, olefins, and aromatics. (lighters, electrical switches, static electricity, high-frequency signals... read more